The AirMind® MindRacer series is a fully stackable flight platform for miniature UAVs.</sup>.
MindRacer is a fully stackable flight platform for miniature UAVs. Based on MindPX, MindRacer further scales down in formfactor while focused on providing modularity. MindRacer is a platform rather than a flight controller.
MindRacer implements the SEP (soldering-elimination-port) and WEP (wiring-elimination-protocol) concepts. Before SEP and WEP, soldering and wiring are always the major pain and efficiency killer during UAV manufacturing and tuning.
The main hardware documentation is here.
- Ultra mini size, weight ~6g
- High performance STM32F427 168MHz floating point processor, super fast throttle response
- Support OneShot ESC
- Support PPM/SBUS/DSM radio receivers, support D.Port/S.Port/Wifi telemetry
- On board flight data recorder
- Support IMU isolation
- DroneCode® standard compliance connector
|PWM Outputs||maximum 6|
|Telemetry||FrSky® D.Port, S.Port, Wifi, 3DR radio|
|On board TF card for flight data recording||YES|
|OneShot ESC Support||YES|
|On board Real time clock||YES|
|Connector||JST GH(compliance with DroneCode standard)|
大多数用户将不需要建立此固件! 它是预构建的, 并在连接适当的硬件时由 QGroundControl 自动安装。
To build PX4 for this target:
MindRacer has an attached Adapt IO board.
MindRacer has a built-in UART-to-USB converter. To connect a companion computer, stack MindRacer on an interface board, and connect the companion computer to the USB port on the interface board.
And the max BAUD rate is the same with px4 family, which is up to 921600.
The user guide is here
MindRacer is available at AirMind Store. You can also find MindRacer at Amazon® or eBay®.